The Gentex S1209F is a photoelectric type smoke alarm that provides
audible alerting for fire safety, has battery backup and can can be used
with Gentex remote strobes for added visual alerting or an alarm system/autodialer for remote notification.
Old Code: 1014, New Code: TA1
The Temp Alert can be used with all Sensaphone models to monitor air temperature from -30 to 130 F (-34 to 54 C). Simply determine the acceptable temperature limits for your application by adjusting the temperature limit arms. When the temperature exceeds the setting, the sensor triggers an alarm.
Detects the presence of water on a horizontal surface.
INDEPENDENTLY POWERED* by internal lithium batteries.
Multiple sensors can be wired in series to a single input.
Comes with 10' of hookup wire. (Additional wire available for purchase...see part number FGD-0010 or FGD-0010B).
*It is essential that any water sensor used with the Sensaphone or a WisDom Wireless Universal Transmitter be self-powered.
Old Code: M-001-0076, New Code: PS110
A compact power outage monitoring device to protect against power outages. The Power-Out Alert easily plugs into any 110 VAC receptacle outlet for operation.Works with all Sensaphone products. Output is Normally Open. Includes 15 ft. cable.
Note: This unit has an activation delay of approximately 3.
10 foot length of WaterRope for the FGD-0056 Zone Water Detector.
Up to ten (10) lengths of 10 foot rope (total length 100 feet) can be cascaded from a single Zone Water Detector.
Dimensions: 10 feet long
Compatible with the FGD-0056 Zone Water Detector.
Old Code: 1200, New Code MTA1
The professional looking MTA-1 Mechanical Temp Alert adds reliable and economical temperature protection to your residential or commercial security system* or Sensaphone Autodialer. The design can be used anywhere the monitoring of high and low temperature limits is critical.
The model WB-200 operates on 12 or 24 Volt AC/DC and has a form C relay output that can be connected to alarm panels, bells, dialers, etc. The unit can monitor up to as many as six sensor probes wired in parallel, up to 100 feet away using 22-18 AWG twisted pair. Each sensor probe has two contacts.
Old Code: 1047, New Code: WB350
Use with your Sensaphone for invaluable protection against costly water damage!
When used with WisDom, either use your one wired zone or use with a Universal Transmitter to make it wireless
The model WB-350 operates on a 9-volt transistor battery
(Not included) has an open collector output that can be connected to alarm panels, bells, dialers, etc.
The standard Under Carpet Water probe is unsupervised and can be connected to the full line of WaterBug products. Alarm will sound when water is detected but no alarm will sound if the cable is cut.
Under carpet water sensor.
Monitor two zones with one on-board temperature sensor and an additional remote temperature, humidity or water sensing probe. If temperatures and/or humidity deviate from the preset limits or water forms a bridge between the contacts on the WaterBug® sensor, the designate relay for each zone will activate an alarm, dialer, siren, etc.
The Detectit Hardwired Wastewater Backup Alarm comes with a sensor that screws right into the main house trap and is equipped with a diaphragm that when pushed up by backing up waste water it will trigger your alarm system. The DETECTIT can be connected to an alarm panel or autodialer so you can get alerts from your home, investment property, cottage, or office when your not there.
SELF-POWERED infrared sensor that monitors the movement of warm bodies in a specific area. Will cause a dialout if motion is detected.
The range is a maximum of 40 feet directly ahead of, and approximately 20 feet to either side of, the detector at 40 feet distance (see installation instructions for diagram).
The GN-503FF is a combination photoelectric smoke and electrochemical sensor carbon monoxide alarm with battery backup for reliable notification in homes, apartments, hospitals, hotels, motels and other commercial properties.
This unit features two alarm contacts that activate independently for smoke and CO events.
This combination smoke and carbon monoxide alarm is hard wired with battery backup for reliable notification in homes, apartments, hospitals, hotels, motels and other commercial properties. This is a photoelectric single station smoke alarm with electrochemical sensor carbon monoxide alarm.
Your shopping cart is currently empty. Please navigate to a product and click "Add to Cart" to purchase it.
If you are having trouble adding an item to the cart, your browser or anti-virus software may be blocking cookies. Our system uses "cookies" to store a unique session identifier, which allows it to maintain shopping cart selections from one page to the next. Please enable cookies in your browser or anti-virus program in order to use our online checkout.
We are always happy to assist you with your order by phone at 1-800-487-1363 x127 (M-F 8-5 EST) or by email at firstname.lastname@example.org.